1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Wiggle on right motor in nascar

Discussion in 'DIY Motion Simulator Projects' started by Lorien31, May 5, 2016.

  1. Lorien31

    Lorien31 Member Gold Contributor

    Joined:
    Aug 5, 2015
    Messages:
    32
    Occupation:
    IT System Specialist
    Location:
    Switzerland
    Balance:
    140Coins
    Ratings:
    +10 / 0 / -0
    My Motion Simulator:
    3DOF, DC motor, Arduino
    Hi all

    just noticed that my right motor which does not have that much load in iracing nascar, does wiggle sometimes.
    If i lean more to the right, it stops because of the load.
    I do not have this issue on the road courses, so i don't want to change much.

    As far as i know i can not add filters to different profiles right ?

    Which filter would be the right one, is it deadzone ?
    Lorien31, May 5, 2016
    #1
  2. bruce stephen

    bruce stephen Hammer doesnt fix it, must be electrical

    Joined:
    Jun 7, 2015
    Messages:
    1,286
    Occupation:
    general contractor
    Location:
    michigan
    Balance:
    9,110Coins
    Ratings:
    +1,238 / 9 / -0
    My Motion Simulator:
    2DOF, DC motor, Arduino, Motion platform, 6DOF
    I would start by isolating which effect it is happening on by trying them out one at a time. for example first surge then sway and so on. then try adding smoothing maybe ten at a time then testing. or go to tunning center and slightly increase the values of the effect that it is happening on. If it is sway then you are correct with deadzone. I run a value near 2 in I racing to reduce twitch in the corner and to dumb down the side to side snap a little as it feels strange on ovals coming out of the turns without it and smoothing together.
    • Like Like x 2
    Last edited: May 6, 2016
    bruce stephen, May 6, 2016
    #2