1. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  2. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  3. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

Question SMC behavior wen loosing contact to Potentiometer.

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by Skuldi, Aug 29, 2020.

  1. Skuldi

    Skuldi New Member

    Joined:
    Aug 16, 2020
    Messages:
    12
    Location:
    Germany NRW
    Balance:
    79Coins
    Ratings:
    +9 / 0 / -0
    My Motion Simulator:
    2DOF, Arduino
    Hello Everyone!

    I build my own 2DOF Motion Seat and Today was my first Test with Life for Speed.

    Everything was fin until I hit a Wall. At that Moment one Motor starts slowly to spin and did not stop until I cut power.



    After some Troubleshooting I found out, that the magnet on Motor 1 lost contact to the Sensor (RTP180LVEAA).

    In SMC the green Line falls under the red Line and the Button in the upper left changes to off. Sadly the Motor keeps on spinning.

    I can reproduce the Error by dragging the Wire out of a0 or a1 on the Arduino will one motor is in motion. Again in SMC the green Line falls under the red one but the Motor keeps spinning.

    Is this a Bug ?
  2. Ads Master

    Ads Master

    Balance:
    Coins
    Ratings:
    +0 / 0 / -0