1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

Question about sabertooth 2x32 and dual 60a drivers

Discussion in 'Motor actuators and drivers' started by Daguru, Jan 10, 2017.

  1. Daguru

    Daguru Rally drivers do it in the Dirt

    Joined:
    Sep 4, 2013
    Messages:
    719
    Occupation:
    Kitchen installer
    Location:
    Wales uk
    Balance:
    453Coins
    Ratings:
    +632 / 1 / -0
    My Motion Simulator:
    Motion platform
    Hi all,
    I was thinking of going over to either of the sabertooth drivers above, And to my question what power supply would I need to run both motors with it at the moment I'm running 2x DPS-600pb one for each motor 90ZYT-155 12v @23amps
    I'm guessing it would need to be a fair bit more than the combined 46amps that the motors need?