1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Poti problem

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by kaminolo, Oct 12, 2010.

  1. kaminolo

    kaminolo New Member

    Joined:
    Feb 23, 2010
    Messages:
    9
    Balance:
    0Coins
    Ratings:
    +0 / 0 / -0
    Hello everyone and sorry again my inglese.I use a translator. I finished my simulator but now I have a problem and wanted to ask you.For information and use dc motors are installed to the right of a structure and a rear center position. I can run those commands with a 129 + vm110 and 8 relay and everything ok. My problem is poti.I use x-sim 1.6. I see the G25 as a blue dot and potentiometers red dot.when active a command for example right, the board sends the command to the relay and the engine starts. When the poti comes off the lead and bringing the G25 in the center of the platform also returns. The problem is when the poti going back because it passes over the center part of the reverse command to return the platform axis, so I stay with the platform folded and not perfectly centre.I do not understand is how they work or how to make the potentiometers I see them run a setup correctly. manually moving them so they are connected properly, right? What moves the platform? The G25, the poti or both? Excuse me if I can not explain it well and thanks to all for advice. Paul
    kaminolo, Oct 12, 2010
    #1