1. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Download Package Now!
  2. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  3. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant here. Do not following these rules will lead to permanent exclusion from this website: Read the forum rules.

Question Does simtool run on other actuators other than SNC 5?

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by saiRyu, Apr 16, 2018.

  1. saiRyu

    saiRyu New Member Gold Contributor

    Joined:
    Jul 1, 2017
    Messages:
    18
    Location:
    japan
    Balance:
    130Coins
    Ratings:
    +0 / 0 / -0
    My Motion Simulator:
    2DOF, DC motor, Arduino
    Hello! Does simtool run on other actuators other than SNC 5?
  2. noorbeast

    noorbeast VR - The Next Generation Staff Member Moderator SimTools 2.0 Beta Tester

    Joined:
    Jul 13, 2014
    Messages:
    11,212
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    St Helens, Tasmania, Australia
    Balance:
    87,822Coins
    Ratings:
    +7,421 / 35 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    SimTools will run with SCN 6, DIY actuators, plus any actuator where the communication control protocol is known.