1. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  2. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  3. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

Question Arduino for Flight Yoke

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by terry wells, Feb 18, 2021.

  1. terry wells

    terry wells Active Member

    Jan 19, 2014
    retired military
    minnesota USA
    +55 / 1 / -0
    My Motion Simulator:
    3DOF, Arduino
    This may not be the right place to post this question but here it is. I am thinking about building a Force Feed Back (FFB) yoke assy for my motion flight simulator. I have been looking around and the "ones" that are available are quite expensive. Here's my question: Can I use the Arduino board along with a motor controller for this and if the answer is yes, what sketch would I use??? I have looked into BFF CL system however the software is quite expensive.


    Attached Files:

  2. Ads Master

    Ads Master

    +0 / 0 / -0