1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

Bug SimTools - Output Testing - Problem - 2DOF

Discussion in 'SimTools DIY Version' started by Hugo Loureiro, Aug 6, 2015.

  1. Hugo Loureiro

    Hugo Loureiro New Member

    Joined:
    Jul 17, 2015
    Messages:
    2
    Location:
    Portugal
    Balance:
    143Coins
    Ratings:
    +0 / 0 / -0
    My Motion Simulator:
    2DOF, Arduino
    Hello,
    I need some help. I am using the Simtools and the Arduino to test a 2DOF system. I know I can get Simtools packets, because I'm doing debugging with Arduino to a serial terminal on my PC. However there is a strange phenomenon. When I enable the "Output Testing", I select "Axis Output" and then displace the "Axis 1" bar to +100%. Then displace "Axis 2" bar to +100% and see the normal data arriving. However, if I move the "Axis 1" bar to -100% and then move "Axis 2" -100% data block always the on same value (0%). If I reset the "Axis 1" (0%), then the "Axis 2" passes to the -100%.

    This has happened to somebody else?

    Thank you for your help.

    Best regards,

    Hugo.


    P.S.: Excuse my bad English. :)