1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question about connexion servo and motor controller

Discussion in 'Motor actuators and drivers' started by fredos16, Jan 3, 2011.

  1. fredos16

    fredos16 New Member

    Joined:
    Oct 4, 2010
    Messages:
    1
    Balance:
    0Coins
    Ratings:
    +0 / 0 / -0
    Hi,

    I am new here and sorry for my english, i try to built 2dof simulator but my problem i not sure
    how connect my hardware. I have two motor controller cytron md30b http://www.robotshop.ca/content/PDF/use ... -md30b.pdf
    and pololu 6 channel http://www.pololu.com/catalog/product/1350/resources, and a 2 futaba servo.i check on internet
    and see different example i not sure what is good for me, i see a example is the servo is connected to motor shaft for position
    and 2 wire is soldered inside of servo circuit and is connect to motor controller, i think is the solution for me but i not sure
    how connect that and i not sure my two motor controller is good for that. and my motor is wiper motor.my question is that how connect
    my hardware motor controller and servo , and is this solution is not working with my motor controller you have another choice
    Thank.
    fredos16, Jan 3, 2011
    #1