1. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  2. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  3. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules

Question One of the motors move more than the other

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by absyfadhel1, Nov 8, 2020.

  1. absyfadhel1

    absyfadhel1 Member

    Joined:
    Oct 19, 2017
    Messages:
    99
    Location:
    bahrain
    Balance:
    84Coins
    Ratings:
    +6 / 0 / -0
    My Motion Simulator:
    2DOF, Arduino
    hi One of the motors move more than the other, i mean when i open simtools and the seat is on the center and its ok but when i move the seat up its go up and a little left and when i move it down its go down and left not center!!

    in roll its same when i roll it to left its go in good movement but if i roll it to right its roll a little i dont know why??

    what i try:
    * reprogram the arduino
    *edit the setting on smc3 and cofirmed that the both motor is same setting
    * confirmd that simtools axis adjustment
    *change the percent for one of the motor and nothing helped

    this is my setting

    1.png

    2.png
  2. Ads Master

    Ads Master

    Balance:
    Coins
    Ratings:
    +0 / 0 / -0
  3. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    15,804
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    St Helens, Tasmania, Australia
    Balance:
    115,446Coins
    Ratings:
    +9,228 / 46 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    Just to clarif, in SMC3 the motors should behave the same, they may not have exactly the same settings. So do both motors move exactly the same in SMC3?
  4. absyfadhel1

    absyfadhel1 Member

    Joined:
    Oct 19, 2017
    Messages:
    99
    Location:
    bahrain
    Balance:
    84Coins
    Ratings:
    +6 / 0 / -0
    My Motion Simulator:
    2DOF, Arduino
    no when i put out manual and pull the blue dot up its work fine and smooth but when i pull it down a bit the motor move like i pull it so hard
  5. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    15,804
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    St Helens, Tasmania, Australia
    Balance:
    115,446Coins
    Ratings:
    +9,228 / 46 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    SMC3 has to be fully sorted first, so go through the set up steps for each motor.