1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Looking for plan for Chair...

Discussion in 'Marketspace - Marktplatz' started by Artistichalo, Jul 20, 2017.

  1. Artistichalo

    Artistichalo Member

    Joined:
    Sep 8, 2016
    Messages:
    45
    Location:
    South Florida
    Balance:
    511Coins
    Ratings:
    +1 / 0 / -0
    Hello everyone Looking for plans to weld a 2DOF chair motion bracket with u-Bolt similar to
    (Sim Experience 2DOF kit ) also if some one can tell me where I can get the rods and actuator covers or something similar to the ones used on (Sim Experience 2DOF kit) or even just something that will support the actuators. Thank you.
    Artistichalo, Jul 20, 2017
    #1
  2. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    20,551
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    St Helens, Tasmania, Australia
    Balance:
    145,124Coins
    Ratings:
    +10,778 / 52 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    There are plenty of SCN powered DIY rigs and information available, you will just need to spend some time in the FAQs and member project threads:

    https://www.xsimulator.net/community/forums/diy-motion-simulator-projects.22/

    https://www.xsimulator.net/community/faq/scn5-scn6.2/category

    Here are a couple of example rigs:

    https://www.xsimulator.net/community/threads/my-scn5-sim.5343/

    https://www.xsimulator.net/community/threads/blecos-2dof-scn5-racing-simulator.2625/

    There are not plans as such but again the FAQs have all you need, just spend some time researching: https://www.xsimulator.net/community/faq/design-considerations-resources.24/category
    Last edited: Jul 20, 2017
    noorbeast, Jul 20, 2017
    #2