1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Advice with motor drivers

Discussion in 'SimTools compatible interfaces' started by Andyc1989, Jun 7, 2012.

  1. Andyc1989

    Andyc1989 New Member

    Joined:
    Jun 6, 2012
    Messages:
    1
    Balance:
    0Coins
    Ratings:
    +0 / 0 / -0
    Hi All

    please forgive me if this has been a previous post, but i am looking for a bit of general guidance regarding what type of motor drivers thing is im looking a building a 3dof (for both flight sims and racing games maybe even implimenting old snes roms mario kart and starfox etc) to start using the Arduino mega controller card (mainly due to cost) and i wondered if someone could be so kind as to help me with the relevant motor drivers ive seen people mention the mdo3 but dont fancy £50+ for each motor especially when im looking to do a 6dof in the near future, is there a way to adapt thanos' mosfet/relay driver?

    many thanks in advance


    Andy
    Andyc1989, Jun 7, 2012
    #1