1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

12v wiper motor wiring

Discussion in 'Motor actuators and drivers' started by Nicko355, Aug 3, 2015.

  1. Nicko355

    Nicko355 New Member

    Joined:
    Oct 17, 2009
    Messages:
    27
    Occupation:
    Automotive Tech
    Location:
    Sydney , Australia
    Balance:
    483Coins
    Ratings:
    +15 / 0 / -0
    My Motion Simulator:
    2DOF, DC motor, Arduino
    Hi ,when using my new sim I find the 1 motor gets hot and the other barely warm . The motors are not identical. I replaced with another smaller dissimilar motor and it was also getting hot. I then replace MM board and still getting hot. I then wire the motor to the slow speed ( brushes that are opposite each other ) and it seems good, my question is should I always use the slow speed brushes ? Cheers Nick
    Nicko355, Aug 3, 2015
    #1