1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Help programming the mjoy16

Discussion in 'DIY peripherals' started by matrix1791, Dec 4, 2010.

  1. matrix1791

    matrix1791 New Member

    Joined:
    Dec 3, 2010
    Messages:
    4
    Balance:
    0Coins
    Ratings:
    +0 / 0 / -0
    I have a usb based- usbtiny and avrisp mkI programmer(both have a 10 way idc cable compatible with the 10 pin header on the mjoy16).
    To program the mjoy16 I need to connect the idc cable to the mjoy isp and the other end of the programmer to the usb.
    Do I need to plug the mjoy16 to the usb separately?

    Also do I need the 330ohms resistors(which are on the original mjoy16 pcb)?

    Is programing the mcu separately on a target board a better option?
    matrix1791, Dec 4, 2010
    #1
  2. Frakk

    Frakk Active Member

    Joined:
    Apr 15, 2009
    Messages:
    1,144
    Balance:
    328Coins
    Ratings:
    +4 / 0 / -0
    You should not need 330ohm resistors with usbtiny or avris mk1.

    Doesn't matter where you program it. If your programmers supply 5V, then you don't need USB.
    Frakk, Dec 4, 2010
    #2