1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question Wiring connection of AMC-AASD15A and servo driver

Discussion in 'Off Topic - All other stuff here' started by Lucien-L, May 11, 2026 at 03:27.

  1. Lucien-L

    Lucien-L New Member

    Joined:
    Monday
    Messages:
    1
    Balance:
    - 24Coins
    Ratings:
    +0 / 0 / -0
    My Motion Simulator:
    4DOF, 6DOF
    I am a beginner working on a 4DOF simulator project with AMC-AASD15A
    . I have opted to use a servo driver and servo motor different from those specified in the manual.

    After connecting the wiring, I found that the servo motor failed to move. Could anyone please offer some guidance and help me determine whether the issue stems from the DB25 cable?

    The signal voltage for the AMC-AASD15A is 5V, whereas my servo drive operates at 24V. I was quite confused by this discrepancy and unsure how to establish the connection; consequently, during testing, I utilized the servo drive's own enable signal instead.

    I have attached the signal diagram for the servo motor, along with my connection diagram. Could you please take a look at them? Thank you very much. 微信图片_20260506154145_274_2244.png 微信图片_20260511090830_10925_11.jpg 微信图片_20260505172244_43_2242.png
    Lucien-L, May 11, 2026 at 03:27
    #1