1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question when simhub is running, simtools motion stops working

Discussion in 'SimTools DIY Version' started by pikky, Dec 29, 2025.

  1. pikky

    pikky New Member Gold Contributor

    Joined:
    Sep 18, 2024
    Messages:
    26
    Balance:
    34Coins
    Ratings:
    +4 / 0 / -0
    My Motion Simulator:
    3DOF
    how can i prevent simtools from conflicting with simhub when using the same motion system (aasd/arduino)? when simhub is running, simtools motion stops working. is there a recommended setup or port/interface configuration so both can coexist without conflict?
    pikky, Dec 29, 2025
    #1
  2. noorbeast

    noorbeast VR Tassie Devil Staff Member Moderator Race Director

    Joined:
    Jul 13, 2014
    Messages:
    21,957
    Occupation:
    Innovative tech specialist for NGOs
    Location:
    Tasmania, Australia
    Balance:
    153,353Coins
    Ratings:
    +11,136 / 57 / -2
    My Motion Simulator:
    3DOF, DC motor, JRK
    • Like Like x 1
    noorbeast, Dec 29, 2025
    #2
  3. Silas

    Silas New Member

    Joined:
    Dec 21, 2025
    Messages:
    4
    Balance:
    34Coins
    Ratings:
    +1 / 0 / -0
    My Motion Simulator:
    DC motor, 6DOF
    SimTools and SimHub usually can’t run at the same time on the same motion system. It is best to use one at a time or set up separate virtual ports for each to avoid conflicts.
    • Like Like x 1
    Silas, Jan 3, 2026
    #3
  4. pikky

    pikky New Member Gold Contributor

    Joined:
    Sep 18, 2024
    Messages:
    26
    Balance:
    34Coins
    Ratings:
    +4 / 0 / -0
    My Motion Simulator:
    3DOF
    I've switched to SimTools v3 now, so I've eliminated the signal interference issue. Thank you.
    • Like Like x 1
    pikky, Jan 5, 2026
    #4