1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Question Simtuning G seat Sway no negative beyond center on a flap while one raise. Or axis neg clamp?

Discussion in 'SimTools DIY Version' started by Trigen, Feb 2, 2019.

Page 2 of 2
  1. Trigen

    Trigen Active Member

    Joined:
    Nov 25, 2018
    Messages:
    472
    Balance:
    2,826Coins
    Ratings:
    +176 / 1 / -0
    My Motion Simulator:
    2DOF, 3DOF, DC motor, Arduino
    Thanks BlazinH ill look into that.
    Last edited: Mar 20, 2019
    Trigen, Mar 20, 2019
    #21
  2. Trigen

    Trigen Active Member

    Joined:
    Nov 25, 2018
    Messages:
    472
    Balance:
    2,826Coins
    Ratings:
    +176 / 1 / -0
    My Motion Simulator:
    2DOF, 3DOF, DC motor, Arduino
    Apologies for the late reply here.

    Ive been doing a complete overhall of the seat the last couple of days and decided to use hall sensors. Its actually working very well with about 10-15% left on the sensor range for my use. And you can just reverse the magnet for polarity.

    It turned out it was overshooting so thanks for that. Lowering KP helped a lot on that part.
    • Like Like x 1
    Trigen, Mar 21, 2019
    #22
Page 2 of 2