1. Do not share user accounts! Any account that is shared by another person will be blocked and closed. This means: we will close not only the account that is shared, but also the main account of the user who uses another person's account. We have the ability to detect account sharing, so please do not try to cheat the system. This action will take place on 04/18/2023. Read all forum rules.
    Dismiss Notice
  2. For downloading SimTools plugins you need a Download Package. Get it with virtual coins that you receive for forum activity or Buy Download Package - We have a zero Spam tolerance so read our forum rules first.

    Buy Now a Download Plan!
  3. Do not try to cheat our system and do not post an unnecessary amount of useless posts only to earn credits here. We have a zero spam tolerance policy and this will cause a ban of your user account. Otherwise we wish you a pleasant stay here! Read the forum rules
  4. We have a few rules which you need to read and accept before posting anything here! Following these rules will keep the forum clean and your stay pleasant. Do not follow these rules can lead to permanent exclusion from this website: Read the forum rules.
    Are you a company? Read our company rules
Shared accounts will be removed Plugin Downloads Zero spam policy Forum Rules

Gear motor doesn't run smoothly

Discussion in 'DIY Motion Simulator Building Q&A / FAQ' started by RhaR, Feb 16, 2017.

  1. RhaR

    RhaR New Member

    Joined:
    Oct 4, 2016
    Messages:
    8
    Location:
    USA
    Balance:
    - 29Coins
    Ratings:
    +5 / 0 / -0
    My Motion Simulator:
    2DOF, DC motor, Arduino
    Using Racing Mat 2 DOF Code and Simtools 2.0
    The motor doesn't run well.
    Check the video. Can someone give me some suggestions ?

    RhaR, Feb 16, 2017
    #1
  2. obobo

    obobo Active Member

    Joined:
    Nov 8, 2016
    Messages:
    248
    Location:
    France
    Balance:
    1,323Coins
    Ratings:
    +77 / 1 / -0
    My Motion Simulator:
    2DOF, DC motor, Arduino
    adjusting PID for the motor ...
    checking the pots
    obobo, Feb 16, 2017
    #2
  3. RhaR

    RhaR New Member

    Joined:
    Oct 4, 2016
    Messages:
    8
    Location:
    USA
    Balance:
    - 29Coins
    Ratings:
    +5 / 0 / -0
    My Motion Simulator:
    2DOF, DC motor, Arduino
    I am using 180 degree Hall effect pots. Is it possible that they are too sensitive? or a gap between the gear box ?
    or problem from china clone MM board because they cannot run RacingMat ultrasonic code ?
    RhaR, Feb 16, 2017
    #3