FlyPT Mover 3.5.3

Try to change the USB port on the pc for one of the Arduinos
Some usb ports share the same bus and might be saturated. That's strange, because this would be a problem in old hardware, not what we have today.
You could try the latest build to see if this works better.
Download here: https://github.com/FlyPTMover/Releases

Setup is not compatible, you have to make a new one and I will have a new build this week (2 more days)

I still don't see some controls even with scaling.
Do you have any plan when you are going to update the Rotating 2DOF rig?
Thanks.

Thanks again for your help.

There is some progress and maybe now there is more useful information.

I was able to get it all to work... but then one set of motors stopped responding after about 10 seconds. I don't get any errors on the screen. Also no errors on the drivers which are connected to the motors.

Next release It's done, but need to solve some bugs in the Recorder/Player, I'm in the middle of that one...
Hope to have it tomorrow.

After an afternoon of searching I'm still sort of stumped. FlyPT is pretty easy to integrate with Thanos or M4S boards. What i need to do is control a single BLDC with a Direct output from FlyPT. Is there a motor controller such as the VESC Minim etc. that can accept the serial stream from Mover and output a proportional torque? If not I assume I need to have an interface board between mover and my driver?

Updated to 3.7.0.15, rotating 2DOF looks good now.
Thank you so much!